Electronics Soldering Technician II

WORK LOCATION: Huntsville, AL
FLSA STATUS: Non-Exempt
SALARY RANGE: The anticipated salary range for this role is $23.00 to $31.00 per hour. This range reflects a good faith estimate based on the targeted level for the role and typical compensation benchmarks across U.S. locations. Actual compensation may vary depending on the selected candidate’s qualifications, experience, geographical location, and internal alignment.
SUMMARY
The Electronics Technician is an integral part of our production team. Under moderate supervision, the Electronics Technician builds assemblies within established timeframes and to document specification, ensuring that all work and components meet rigorous quality standards. The Electronics Technician displays keen attention to detail and supports others in the shop and throughout the company, both technically and as teammates. The electronic technician verifies that products meets all functional requirements, and completes required configuration and calibration activities.
RESPONSIBILITIES
The following job functions are a basic requirement but are not limited to and may be assigned other duties.
Manufactures and assembles cables and wire harnesses, by soldering wires into connectors (cup soldering) and crimping various terminals to populate into housings
Tests and performs functional checks on completed assemblies
Fills out travelers and documents components’ progress through the shop and handles Lot/Serial tracking for product traceability
Regularly uses production tools and equipment including soldering irons, wire cutters, stripper/crimpers, Windows-based PCs, etc.
Performs in-process configuration, calibration, and verification on equipment
Performs functional and mechanical check outs as required
Supports improvement of Test equipment and procedures
Communicates effectively with management and teammates to discuss challenges and support problem resolution
Assumes all other responsibilities as assigned
REQUIRED QUALIFICATIONS
High School Diploma/GED
1+ years of experience soldering and/or hand crimping
Experience in a production setting
PREFERRED QUALIFICATIONS
Experience with cup soldering and JST/Molex crimping
IPC 620 certification or similar